Order Here!

The Wedge Latch - The secret to the success of the Truss-Me System starts with our patent pending wedge latch.  The unique design captures and holds a swinging truss which allows you the ability to align and fasten the truss without having to worry about it coming loose. It is also accomplishes the same thing with racking I-Joists.

Truss-Me Components - The main components of this system that make the system work so well are our patented wedge latches and brackets. Using these will allow you the ability to build the top plates, runners, and starters, or check for the availability of prefabricated Truss-Me components in your area.

Truss-Me Top Plates – The Top Plates can be constructed quick and easily. By attaching the wedge latches to the designated top plate, you end up with pre-measured components that help prevent mistakes when setting your trusses or I-Joists. Once put together, they can be used in every aspect where a top plate is used. From the top plates which the trusses are set on, to the top plates/bottom plates for constructing walls, to the sill plates for setting your floor or I-joists.

Truss-Me Runners - The Runners are used to capture multiple trusses and I-Joists quickly and efficiently, basically eliminating mistakes all while making it that much safer to install trusses and I/floor joists. Instead of spanning a 2x4 out past your trusses to wedge a truss underneath, attach the wedge latches to the 2x4 at your desired measurements, and be able to swing, align, and fasten the truss in under 30 seconds.

Truss-Me Starters - Starters are attached to the gable end truss and are used to capture the first truss swung into place or to the outside band board for your I-Joists. . The starter is easily constructed using one of our patented wedge latches and brackets.
Each componenet of the Truss-Me System contains our wedge latches, which are made right here in the good ole' U.S.A.